Skip to main content

XTM Cloud 13.8

ICE matches

To access the ICE matches parameters, select Configuration > Settings > Translation > TM > ICE matches.

To make changes to the ICE matches settings, select the relevant option for the required parameters and then, select the Save button at the bottom of the screen.

Table 15. ICE matches parameters

Parameter

Description

Populate target with match

You can decide when an ICE match is automatically inserted into the target segment. The options are:

  • Only if inline tags are the same (default)

  • Never

Number of matches to display

You can set a maximum number of ICE matches which are displayed in XTM Workbench, in the Matches docked panel for a single segment. The options are:

  • 1

  • 2

  • 3 (default)

Allow editing of ICE matched segments

This parameter enables Project Managers to decide whether In Context Exact (ICE) matches should be reviewed and edited by Linguists, or not.

You can decide whether this parameter is displayed at customer and project level and what is the default. To do so, use the checkbox in the Permit column:

  • Selected (default) – This parameter is displayed at customer and project level.

    If you also select the checkbox in the Default setting column, the parameter is enabled at customer and project level by default. Project Managers can disable it, if required.

  • Cleared – This parameter is NOT displayed at customer and project level.

Set ICE matches from not approved TM to done

XTM Cloud can automatically set ICE matches from not approved TM to done during project analysis without the need to confirm them in XTM Workbench.

In XTM Workbench this setting will only apply for an active segment in an active workflow step, if the target segment (which has been promoted to ICE match, while the Linguist was working in XTM Workbench) is populated automatically. If a Linguist manually selects ICE match from the Matches docked panel, this setting will not apply, so the segment status will not automatically be set to done.

You can decide if this parameter is available at customer and project level and specify the default. To do so, use the checkbox in the Permit column:

  • Selected – This parameter is displayed at customer level, in project templates and when creating a project.

    If you also select the checkbox in the Default setting column, the parameter will be enabled at customer and project level by default. Project Managers can disable it, if required.

    Additionally, use radio buttons to specify in which workflow steps should these segments be set to done (Completed):

    • All steps – XTM Workbench sets the status of segments with ICE matches from not approved TM to Completed in all workflow steps.

    • First step only – XTM Workbench only sets the status of segments with ICE matches from not approved TM to Completed in the first workflow step.

    • All except last step – XTM Workbench sets the status of segments with ICE matches from not approved TM to Completed in all workflow steps except the last one.

  • Cleared (default) – This parameter is NOT displayed at customer and project level.


In this section: